Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Install the shock to the vehicle.

Fig 1: Identifying Lower Shock Mounting Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the lower shock mounting bolt.
Tighten: Tighten the bolt to 150 N.m (111 lb ft).

Fig 2: View of Shock Absorber Assembly

Courtesy of GENERAL MOTORS CORP.

Guide the shock to the body while lowering the vehicle.

Fig 3: View of Upper Shock Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Install the upper shock mounting nuts.
Tighten: Tighten the nuts to 25 N.m (18 lb ft).
Reposition the sound insulator around the shock tower.
Install the rear seat back. Refer to Rear Seat Back Replacement .