Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Exhaust Tip

Courtesy of GENERAL MOTORS CORP.

Install the NEW exhaust tip to the exhaust pipe, and align to the mark previously made during disassembly.
Re-install the exhaust system to the rear suspension hanger rods, and the tail pipe hanger rods.

Fig 2: Aligning Exhaust Tip

Courtesy of GENERAL MOTORS CORP.

Visually align the exhaust tip to the vehicle.
Tack weld the exhaust tip to the vehicle.

Fig 3: View Of Exhaust System

Courtesy of GENERAL MOTORS CORP.

Remove the exhaust system from the rear suspension hanger rods, and the tail pipe hanger rods.
Weld the exhaust tip to the exhaust pipe in the same locations the original tip had been welded.
Re-install the exhaust system to the rear suspension hanger rods, and the tail pipe hanger rods.