LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1117 (Engine Exhaust System) >> Repair Instructions >> Exhaust Manifold Heat Shield Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Exhaust Manifold Heat Shield Retainers
    GM1562770Courtesy of GENERAL MOTORS CORP.
  1. Install the lower exhaust manifold heat shield (2), if necessary.
  2. Install the lower exhaust manifold heat shield retainers (1), if necessary.
    3. Fig 2: Removing/Installing Exhaust Manifold Heat Shield
    GM1562768Courtesy of GENERAL MOTORS CORP.
  3. Install the exhaust manifold heat shield.
  4. Install but do not tighten the exhaust manifold heat shield lower bolt.
  5. Lower the vehicle.
    6. NOTE: Refer to Fastener Notice .
  6. Install the exhaust manifold heat shield upper bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  8. Tighten the exhaust manifold heat shield lower bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  9. Lower the vehicle.
scientia non olet · About LEMON Manuals