LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1116 (Wheel Alignment System) >> Repair Instructions >> Front Caster and Camber Adjustment (AWD) >> Procedures

Front Caster and Camber Adjustment (AWD): Procedures

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of J 45845
    GM802484Courtesy of GENERAL MOTORS CORP.
  1. Install the J 45845  or the J-45845-10  to the lower control arm and the frame. See Special Tools .
  2. Loosen the lower control arm to frame bolt.
    3. NOTE: Refer to Fastener Notice .
  3. Adjust the camber angle by turning the turnbuckle on J 45845  or the J-45845-10  until the specifications have been met. See Special Tools .

    Tighten:  Tighten the bolt to 135 N.m (96 lb ft).

  4. Verify that the camber is still with specifications. Refer to Wheel Alignment Specifications .
  5. Adjust the rear toe. Refer to Rear Toe Adjustment .
scientia non olet · About LEMON Manuals