LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1115 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (RWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The ball stud must not rotate during disassembly or reassembly. Hand tools must be used to keep the ball stud from rotating. If air tools are used and the stud is allowed to rotate, damage to the ball stud and/or stud mounting hole may occur.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Identifying ABS Sensor Wiring Harness At The Stabilizer Shaft Links
    GM746681Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the antilock brake system (ABS) sensor wiring harness from the stabilizer shaft link.
    4. Fig 2: Removing & Installing Stabilizer Shaft Link
    GM750841Courtesy of GENERAL MOTORS CORP.
  4. Remove the stabilizer shaft link retaining nuts.
  5. Remove the stabilizer shaft link.
scientia non olet · About LEMON Manuals