Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel bearing/hub.
- Install the wheel bearing/hub bolts.
Tighten: Tighten the bolts to 135 N.m (100 lb ft).
- Connect the ABS electrical connector.
- Install the brake rotor. Refer to Front Brake Rotor Replacement (RWD) or Front Brake Rotor Replacement (AWD) .
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
.