LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Engine Mechanical - 3.6L (2 Of 6)) >> On-Vehicle Repair Instructions (1 Of 2) >> Water Pump And Generator Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Generator & Water Pump Drive Belt Routing
    GM1285186Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt to the crankshaft pulley, the tensioner and the generator.
  2. Rotate the drive belt tensioner clockwise.
  3. Install the drive belt to the water pump.
    4. IMPORTANT: Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
  4. Slowly release the drive belt tensioner.
  5. Install the front compartment sight shield as necessary. Refer to Front Compartment Sight Shields Replacement .
scientia non olet · About LEMON Manuals