LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Engine Mechanical - 3.6L (2 Of 6)) >> On-Vehicle Repair Instructions (1 Of 2) >> Oil Level Indicator And Tube Replacement (LY7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube
    GM902882Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the front compartment sight shield as necessary. Refer to Front Compartment Sight Shields Replacement .
  3. Remove the oil level indicator from the oil level indicator tube.
  4. Remove the oil level indicator tube bolt.
  5. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the knock sensor. Refer to Knock Sensor Replacement - Bank 2 .
  7. Remove the heat shield clip from the oil level indicator tube.
  8. Lower the vehicle.
    9. IMPORTANT: Note the location and orientation of the secondary (small square) heat shield.
  9. Remove the oil level indicator tube up through the exhaust manifold.
  10. If you are replacing only the oil level indicator tube seal, remove and discard the old seal.
scientia non olet · About LEMON Manuals