LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Engine Mechanical - 3.6L (2 Of 6)) >> On-Vehicle Repair Instructions (1 Of 2) >> Oil Level Indicator And Tube Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube
    GM902882Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the secondary (small square) heat shield is properly installed to the oil level indicator tube as noted during removal.
  1. Install the oil level indicator and tube. Refer to Oil Level Indicator and Tube Installation .
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Install the knock sensor. Refer to Knock Sensor Replacement - Bank 2 .
  4. Install the heat shield clip to the oil level indicator tube as noted during removal.
  5. Lower the vehicle.
  6. Install the front compartment sight shield as necessary. Refer to Front Compartment Sight Shields Replacement .
scientia non olet · About LEMON Manuals