LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Engine Mechanical - 3.6L (2 Of 6)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Bracket Replacement - Right Side (W/RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Engine Mount Bracket
    GM1283926Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the engine mount bracket mounting bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

  3. Install the starter. Refer to Starter Motor Replacement (LY7) .
    4. Fig 2: View Of Right Engine Mount
    GM1283925Courtesy of GENERAL MOTORS CORP.
  4. Install the engine mount to the vehicle.
  5. Install the upper engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

    6. Fig 3: Identifying Frame Mounting Nuts
    GM785352Courtesy of GENERAL MOTORS CORP.
  6. Lower the engine using the jack screw until the weight is resting on the mount.
  7. Install the engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  8. Remove the screw jack and block of wood from under the oil pan.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals