Circuit/System Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the inline harness connector at the outside rearview mirror.
- Install a test lamp between the control circuit terminal 7 and the control circuit terminal 5.
- Ignition ON, commanded the mirrors to extend and retract using the power folding switch. The test lamp turn ON and OFF when changing between the commanded states.
- If the test lamp is always ON, test both control circuits for a short to voltage. If the circuit tests normal, replace the appropriate door module.
- If the test lamp is always OFF, test both control circuits for a short to ground or an open/high resistance. If the circuit tests normal, replace the appropriate door module.
- If all circuits test normal, test or replace the outside rearview mirror motor.