LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1110 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Front Side Door Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Window Regulator Clamp
    GM758771Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The window regulator should be at least 1/2 way down before installing the window.
  1. Install the window down into the door.
  2. Locate the window into the 2 window regulator clamps.
    3. IMPORTANT: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
  3. Start the vehicle.
    4. NOTE: Refer to Fastener Notice .
  4. Using the power window switch, raise the window to the fully closed position.

    Tighten:  Tighten the window clamp nuts to 11 N.m (98 lb in).

  5. Install the window inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  6. Inspect for proper window operation and a tight seal.
  7. Shut off the vehicle.
  8. Install the water deflector.
  9. Install the door control module. Refer to Control Module References .
  10. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals