Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Door Window Regulator Assembly

Courtesy of GENERAL MOTORS CORP.

Install the window regulator into the door.

NOTE: Refer to Fastener Notice .

Install the window regulator bolts (1, 2, 3, 4, 5).
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Remove the tape from the window.
Lower the window into the window regulator clamps.
The glass must be fully rearward into the window channel when it is seated in the window clamps.
Connect the power window motor electrical connector.

IMPORTANT: Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.

Start the vehicle.
Raise the window to the full up position.
Tighten: Tighten the window clamp nuts to 11 N.m (95 lb in).
Check for proper window operation and a tight seal.
Shut off the vehicle.
Install the water deflector.
Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .