LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1109 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (LY7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Positive Lead & Generator BAT Terminal Nut
    GM887703Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) .
  2. Remove the drive belt from the generator. Refer to Water Pump and Generator Belt Replacement .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the electrical connector (1) from the generator.
  5. Reposition the protective boot from the generator output BAT terminal for access.
  6. Remove the generator output BAT terminal nut (3) and disconnect the battery positive lead (2) from the generator.
    7. Fig 2: View Of Generator
    GM887706Courtesy of GENERAL MOTORS CORP.
  7. Remove the generator lower bolts.
  8. Lower the vehicle.
  9. Remove the generator upper bolt.
  10. Remove the generator from the engine.
scientia non olet · About LEMON Manuals