Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Position the battery positive cable to the engine.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 1: View Of Starter Terminal Nut & Battery Positive Cable

GM887713

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Connect the battery positive cable (2) to the starter and install the starter terminal nut (1).
Tighten: Tighten the nut to 13 N.m (115 lb in).

Fig 2: View Of Battery Positive Lead & Generator BAT Terminal Nut

GM887703

Courtesy of GENERAL MOTORS CORP.

Connect the battery positive lead (2) to the generator and install the generator BAT terminal nut (3).
Tighten: Tighten the nut to 13 N.m (115 lb in).
Install the protective boot to the generator output BAT terminal.
Lower the vehicle.

Fig 3: Identifying Battery Positive Cable To Underhood Fuse Block

GM772415

Courtesy of GENERAL MOTORS CORP.

Install the nut (1) securing the battery positive cable (2) to the underhood fuse block.
Tighten: Tighten the nut to 15 N.m (11 lb ft).

Fig 4: View Of Underhood Fuse Box

GM785724

Courtesy of GENERAL MOTORS CORP.

Install the electrical center cover.

Fig 5: View Of Battery Positive & Negative Cables

GM772424

Courtesy of GENERAL MOTORS CORP.

Connect the battery positive cable to the battery.
Tighten: Tighten the bolt to 17 N.m (13 lb ft).
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) .