LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1108 (Tire Pressure Monitoring System) >> Repair Instructions >> Low Tire Pressure Indicator Module Replacement (RPO UH3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left rear compartment trim. Refer to Rear Compartment Side Trim Panel Replacement .
  2. Depress the lock tab (1) for the tire pressure indicator monitoring module (TPIM) (3).
  3. Slide the TPIM (3) over the lock tab (1) and remove it from the mounting bracket (2).
  4. Lower the TPIM (3) and remove the electrical connector (4).
  5. Remove the TPIM (2) from the vehicle.
    6. Fig 1: Locating Tire Pressure Indicator Module
    GM1992109Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals