Component Test
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the washer fluid level sensor.
- Washer fluid level switch open, test for infinite resistance between the signal terminal A and the ground terminal B.
- If not the specified value, replace the washer fluid level sensor.
- Washer fluid level switch closed, test for less than 2 ohms of resistance between the signal terminal A and the ground terminal B.
- If not within the specified range, replace the washer fluid level sensor.