Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of J 38836, Washer & Pilot Bearing (without RPO HP2)

Courtesy of GENERAL MOTORS CORP.

Install a 5/8 inch washer (1) onto the J 38836 or equivalent. See Special Tools . The washer serves as a stop against the crankshaft face and will assist in installing the bearing to the proper depth.
Install the new pilot bearing (2) onto the tool.

Fig 2: Installing Pilot Bearing Using J 38836 (without RPO HP2)

Courtesy of GENERAL MOTORS CORP.

Install a new pilot bearing into the crankshaft using the J 38836 . See Special Tools .
Inspect the clutch pilot bearing for proper installation. A properly installed clutch pilot bearing will be installed until flush to the rear of the crankshaft.
Install the clutch. Refer to Clutch Assembly Replacement .