Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Park Brake Release Handle Assembly

Courtesy of GENERAL MOTORS CORP.

Install the park brake release handle (2) to the park brake release cable (1).
Install the park brake release cable housing (3) to the park brake release handle assembly (1).
Install the park brake release handle assembly (1) to the knee bolster.

NOTE: Refer to Fastener Notice .

Install the park brake release handle bolts.
Tighten: Tighten the bolts to 3 N.m (27 lb in).
Install the driver knee bolster. Refer to Driver Knee Bolster Replacement .