LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Rear Park Brake Cable, Support Bracket & Actuator Lever
    GM751609Courtesy of GENERAL MOTORS CORP.
  1. Install the right rear park brake cable (2) to the right rear park brake cable bracket (1).
  2. Ensure that the locking tabs are properly seated.
  3. Connect the right rear park brake cable (2) to the right rear park brake actuator lever (3).
    4. Fig 2: Identifying Park Brake Cable And Intermediate Park Brake Cable Connector
    GM751605Courtesy of GENERAL MOTORS CORP.
  4. Install the right rear park brake cable (2) to the mounting support bracket (1).
  5. Ensure that the locking tabs are properly seated.
  6. Connect the intermediate park brake cable connector (3) to the right rear park brake cable (2).
    7. Fig 3: View Of Park Brake Cable
    GM492729Courtesy of GENERAL MOTORS CORP.
  7. Pull down on the intermediate park brake cable (2) near the park brake cable connector (1).
  8. Connect the intermediate park brake cable (2) to the park brake connector (1).
  9. Install the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
  11. To ensure that the park brake cable retainers are seated, cycle the park brake pedal 1 to 2 times.
scientia non olet · About LEMON Manuals