Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Left Rear Park Brake Cable, Support Bracket & Actuator Lever

Courtesy of GENERAL MOTORS CORP.

Install the left rear park brake cable (2) to the left rear park brake cable bracket (1).
Ensure that the locking tabs are properly seated.
Connect the left rear park brake cable (2) to the left rear park brake actuator lever (3).

Fig 2: Identifying Park Brake Cable Components

Courtesy of GENERAL MOTORS CORP.

Install the left rear park brake cable (2) to the left rear support mounting bracket (1).
Ensure that the locking tabs are properly seated.

Fig 3: Identifying Park Brake Cable At Equalizer

Courtesy of GENERAL MOTORS CORP.

Connect the left rear park brake cable (2) to the equalizer (1).

Fig 4: View Of Park Brake Cable

Courtesy of GENERAL MOTORS CORP.

Connect the intermediate park brake cable (2) to the park brake cable connector (1).
Install the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
To ensure that the park brake cable retainers are seated, cycle the park brake pedal 1 to 2 times.