LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Parking Brake System) >> Repair Instructions >> Parking Brake Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Parking Brake Indicator Switch Bolt
    GM1970049Courtesy of GENERAL MOTORS CORP.
  1. Assemble the parking brake indicator switch bolt (1) to the parking brake indicator switch (2).
  2. Install the parking brake indicator switch assembly to the parking brake lever.

    Align the pin on the indicator switch to the locator hole on the parking brake lever.

    3. NOTE: Refer to Fastener Notice .
  3. Tighten the parking brake indicator switch bolt.

    Tighten:  Tighten the bolt to 7 N.m (62 lb in).

  4. Connect the parking brake indicator switch electrical connector.
  5. Install the left instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side .
scientia non olet · About LEMON Manuals