LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Parking Brake System) >> Repair Instructions >> Park Brake Release Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Park Brake Cable & Pedal Release Lever
    GM754103Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake cable (1) to the park brake pedal release lever (2).
    2. Fig 2: View Of Park Brake Pedal Assembly & Release Cable Housing
    GM754106Courtesy of GENERAL MOTORS CORP.
  2. Install the park brake release cable housing (2) to the park brake pedal assembly (1).
    3. Fig 3: View Of Park Brake Release Handle Assembly
    GM786887Courtesy of GENERAL MOTORS CORP.
  3. Install the park brake release cable (2) to the park brake release handle assembly (1).
  4. Install the park brake release cable housing (3) to the park brake release handle assembly (1).
  5. Install the park brake release handle assembly (1) to the knee bolster.
    6. NOTE: Refer to Fastener Notice .
  6. Install the park brake release handle bolts.

    Tighten:  Tighten the bolts to 3 N.m (27 lb in).

  7. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement .
scientia non olet · About LEMON Manuals