LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Mounting Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: View of Parking Brake Cable and Connector
    GM1970039Courtesy of GENERAL MOTORS CORP.
  3. Pull down on the intermediate park brake cable and disconnect the intermediate park brake cable connector (1) from the front park brake cable (2).
    4. Fig 2: View Of Left Rear Park Brake Cable, Support Bracket & Actuator Lever
    GM751609Courtesy of GENERAL MOTORS CORP.
  4. Using the J 37043  , compress the rear brake cable retainer. See Special Tools .
  5. Remove the rear park brake cable from the cable bracket (1).
  6. Disconnect the park brake cable (2) from the park brake actuator lever (3).
    7. Fig 3: View of Parking Brake Cable Bracket and Nuts
    GM1970031Courtesy of GENERAL MOTORS CORP.
  7. Remove the park brake cable bracket nuts (1).
  8. Remove the park brake cable bracket.
scientia non olet · About LEMON Manuals