Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the blower motor.
- Install the blower motor screws (1).
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
- Connect the blower motor electrical connector.
- Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
- Install the I/P insulator - right side. Refer to Instrument Panel Insulator Replacement - Right Side .
NOTE:
Refer to Fastener Notice
.