Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the desiccant bag (3).
- Install the filter (2).
- Lubricate the O-rings on the plug with refrigerant oil before installing. Refer to O-Ring Replacement .
- Install the bottom plug (1).
Tighten: Tighten the plug to 12.5 N.m (111 lb in).
- Install the front bumper facia deflector. Refer to Front Bumper Fascia Air Deflector Replacement .
- Lower the vehicle.
- Add the proper amount of oil. Refer to Refrigerant System Capacities .
- Evacuate and recharge the refrigerant. Refer to Refrigerant Recovery and Recharging .
- Leak test the fittings of the component with J 39400-A . See Special Tools .
NOTE:
Refer to Fastener Notice
.