Enabling Procedure - Air Bag Fuse
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Place the ignition in the OFF position.
- Install the fuse(s) supplying power to the SDM. Refer to SIR Schematics or Electrical Center Identification Views .
- Turn the ignition switch to the ON position. The AIR BAG indicator will flash then turn OFF.
- Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle .