Circuit/System Description

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

The seat position sensor is used to determine the proximity of a front driver seat position with respect to the inflatable restraint I/P module. The seat position sensor is a hall effect sensor that is mounted on the seat track of the front driver seat. The seat position sensor is connected to the sensing and diagnostic module (SDM) with a low reference and a signal circuit. The SDM uses the state of the seat position sensor to determine the need for a stage 2 deployment of the inflatable restraint I/P module. When the seat is in the forward position stage 2 deployment is disabled, and when in the rearward position stage 2 deployment is enabled. The SDM monitors the LF seat position sensor signal circuit and if a fault is detected, the SDM will set DTC B0079 and defaults to disabling stage 2 inflatable restraint I/P module deployment.