Rear Hoist Pads

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Hoist Pads

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The rear hoist pads must not contact the rocker panels, the rear fenders, the floor pan, or the stone guard moldings. Remove the jacking covers from the rocker panels if necessary.

Position the frame contact rear hoist pads as follows:

Under the rear frame rail at the rear axle cradle mount flange.
The long sides of the pads, if applicable perpendicular to the frame rails.