Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Position the sensor (3) to the vehicle and engage the locking tab to the wheelhouse bracket.
- Secure the clinch nut (1) in order to secure the sensor (4) to the vehicle.
Tighten: Tighten 9 N.m (80 lb in).
- Secure the ball and socket (3) to sensor (4).
- Connect electrical connector (2) to the sensor (4).
- Install the right tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Set up and program the headlamp control module. Refer to Control Module References .