LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1087 (Lighting Systems) >> Diagnostic Information and Procedures >> Headlamp Leveling Malfunction >> Circuit/System Testing >> Headlamp Leveling Sensor Malfunction

Headlamp Leveling Sensor Malfunction

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate headlamp leveling sensor.
  2. Ignition OFF, test for less than 10.0 ohms between the low reference circuit terminal C and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the headlamp control module.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal A and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the headlamp control module.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the headlamp control module.
  4. Verify the scan tool leveling position sensor parameter is less than 0.5-volts.
    • If greater than the specified range, test the signal circuit terminal B for a short to voltage. If the circuit tests normal, replace the headlamp control module.
  5. Install a 3A fused jumper wire between the signal circuit terminal B and the 5-volt reference circuit terminal A. Verify the scan tool leveling position sensor parameter is greater than 4.8-volts.
    • If less than the specified range, test the signal circuit for short to ground or an open/high resistance. If the circuit tests normal, replace the headlamp control module.
  6. If all circuits test normal, test or replace the appropriate headlamp leveling sensor.