Park, Tail, License and Marker Lamps: European

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

The rear tail, stop, and turn signal functions are performed by light emitting diodes (LED) in the tail lamp assemblies. The tail lamp assemblies wrap around the corner of the vehicle and serve as the rear side marker. The lower portion of each lamp contains reflectors to alert approaching vehicles for nighttime driving safety. Battery positive voltage is applied at all times to both the coil and switch sides of the LT/POS/LP and RT/POS/LP relays located in the rear fuse block. The turn signal/multifunction switch is suppled with ground at G200 at all times. When the headlamp switch is placed in either the HEAD or PARK position, ground is applied to the park lamp signal circuit to the body control module (BCM). The BCM responds by applying ground to the left and right park lamp relay control circuits. This energizes the left and right park lamp relay coils causing the relay switch contacts to close allowing battery voltage to flow through the LT/POS/LP and RT/POS/LP fuses to all of the park, tail, license, and marker lamps. Ground for the front park and marker lamps is supplied at G101 for the left and G102 for the right. Ground for the license, tail, and rear side marker lamps is supplied at G402 for the left and G401 for the right.