LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1072 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Valve Rocker Arm Cover Replacement - Lower Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Valve Rocker Arm Cover (Right)
    GM1335929Courtesy of GENERAL MOTORS CORP.
  1. Install the lower valve rocker arm cover gasket.
  2. Install the lower valve rocker arm cover.
  3. Install the lower valve rocker arm cover bolts.
    4. Fig 2: Lower Valve Rocker Arm Cover Bolts Tightening Sequence
    GM1411029Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Tighten the bolts in the sequence shown.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Install the fuel injectors. Refer to Fuel Injector Replacement (Left) or Fuel Injector Replacement (Right) .
  6. Install the right upper valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Upper Right Side .
scientia non olet · About LEMON Manuals