LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1072 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Oil Filler Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Filler Tube
    GM1335401Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW O-ring seal onto the oil fill tube.
  2. Install the oil fill tube.
    3. Fig 2: View Of Lower Oil Fill Tube Bolt
    GM1873325Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the lower oil fill tube bolt (1).

    Tighten:  Tighten the bolts to 21 N.m (15 lb ft).

    4. Fig 3: View Of Oil Fill Tube Bracket & Bolts
    GM1873245Courtesy of GENERAL MOTORS CORP.
  4. Install the oil fill tube bracket.
  5. Install the oil filler tube bracket bolts.

    Tighten:  Tighten the bolts to 21 N.m (15 lb ft).

    6. Fig 4: View Of Upper Oil Fill Tube Bolt
    GM1873290Courtesy of GENERAL MOTORS CORP.
  6. Install the upper oil fill tube bolt (1).

    Tighten:  Tighten the bolts to 21 N.m (15 lb ft).

  7. Install the drive belt. Refer to Drive Belt Replacement .
  8. Install the fan and clutch assembly. Refer to Cooling Fan and Shroud Replacement (Non-HP2) .
scientia non olet · About LEMON Manuals