Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Determining Sealant Bead Dimensions

Courtesy of GENERAL MOTORS CORP.

Apply a 2-3 mm (0.79-0.118 in) by 0.5-1.5 mm (0.02-0.06 in ) wide bead of sealant to the lower oil pan mating surface. Refer to Sealers, Adhesives, and Lubricants for the correct part number.

Fig 2: View Of Lower Oil Pan & Bolts/Nuts

Courtesy of GENERAL MOTORS CORP.

Install the lower oil pan.
Install the lower oil pan bolts/nuts.

Fig 3: Lower Oil Pan Bolts Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Tighten the oil pan bolts/nuts in the sequence shown.
Tighten: Tighten the bolts/nuts to 10 N.m (89 lb in).

Fig 4: View Of Oil Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the oil level sensor electrical connector.

Fig 5: View Of Crossbar Bolts & Bar (2WD)

Courtesy of GENERAL MOTORS CORP.

If equipped with a 2WD, install the crossmember and bolts.
Tighten: Tighten the bolts to 100 N.m (74 lb ft).

Fig 6: View Of Crossmember Bolts & Bar (4WD Only)

Courtesy of GENERAL MOTORS CORP.

If equipped with a 4WD, install the crossmember and bolts.
Tighten: Tighten the bolts to 100 N.m (74 lb ft).

Fig 7: Identifying Oil Pan Skid Plate

Courtesy of GENERAL MOTORS CORP.

Install the oil pan skid plate and bolts, if equipped.
Tighten: Tighten the bolts to 20 N.m (15 lb ft).
Install NEW engine oil and a oil filter. Refer to Engine Oil and Oil Filter Replacement .
Lower the vehicle.