LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1070 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement (JD9) or Rear Brake Rotor Replacement (JH6) or Rear Brake Rotor Replacement (JH7) .
    4. Fig 1: Removing Wheel Stud From Hub Flange
    GM361843Courtesy of GENERAL MOTORS CORP.
  4. Remove the wheel stud from the hub flange using the J 43631  .
  5. Remove the wheel stud from the hub flange.
scientia non olet · About LEMON Manuals