Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the pitman arm onto the steering gear.

Fig 1: View Of Steering Gear And Pitman Arm

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice.

Install a new pitman arm washer (2) and nut (1).
Tighten: Tighten the nut to 250 N.m (184 lb ft).
Remove the steering gear from the vise.
Install the steering gear. Refer to Steering Gear Replacement (Rack and Pinion) or Steering Gear Replacement (Non-Rack and Pinion) .
Adjust the front toe. Refer to Front Toe Adjustment .