LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1068 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vehicle Speed Sensor (VSS) & O-Ring Seal
    GM819577Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the speed sensor with a NEW O-ring.

    Tighten:  Tighten the sensor to 17 N.m (13 lb ft).

    2. Fig 2: Transfer Case Components
    GM826962Courtesy of GENERAL MOTORS CORP.
  2. Connect the speed sensor electrical connector (4).
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals