LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1067 (Theft Deterrent System) >> Diagnostic Information and Procedures >> Pickup Box Bed Sensor Inoperative >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the bed sensor.
  2. With the switch open, test for infinite resistance between the signal circuit terminal A and the ground circuit terminal B.
    • If not the specified value, replace the bed sensor.
  3. With the switch closed, test for less then 5 ohms between the signal circuit terminal A and the ground circuit terminal B.
    • If greater than the specified range, replace the bed sensor.
scientia non olet · About LEMON Manuals