Intake Manifold Removal

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Ignition Coil & Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the ignition coil bolts and coil from the bracket.

Fig 2: View Of Ignition Coil Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

If required, remove the ignition coil bracket bolts and bracket.

Fig 3: View Of Oil Pump Drive Shaft

Courtesy of GENERAL MOTORS CORP.

Remove the oil pump drive shaft bolt.
Remove the oil pump drive shaft with clamp.

Fig 4: Oil Pump Drive Shaft & Gasket

Courtesy of GENERAL MOTORS CORP.

Remove the oil pump drive shaft gasket and discard.

Fig 5: Evaporative Emission Canister Solenoid Valve & Harness

Courtesy of GENERAL MOTORS CORP.

Remove the evaporative emission (EVAP) canister purge solenoid valve harness.
1. Push the quick disconnect clip and hold in place.
2. Pull outward on the harness elbow.

Fig 6: View Of Intake Manifold Assembly & Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the engine coolant temperature (ECT) sensor wire connector, if equipped, from the engine wiring harness bracket.
Remove the lower intake manifold bolts.

IMPORTANT:

The intake manifold may be removed as an assembly. Do not remove the specific intake manifold components unless component service is required.
Do not allow dirt or debris to enter the fuel system. Ensure that the ends of the fuel system are properly sealed.

Remove the intake manifold assembly.
Remove and discard the lower intake manifold gaskets.