Cylinder Head Removal - Right Side

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Spark Plugs

Courtesy of GENERAL MOTORS CORP.

Remove the spark plugs.

Fig 2: Spark Plug Wire Support

Courtesy of GENERAL MOTORS CORP.

Remove the rear bolt and the spark plug wire support.

Fig 3: Locating Cylinder Head Bolts (Right)

Courtesy of GENERAL MOTORS CORP.

Remove the cylinder head bolts and discard.

Fig 4: Removing/Installing Cylinder Head (Right)

Courtesy of GENERAL MOTORS CORP.

NOTE: After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.

Remove the cylinder head.

Fig 5: View Of Cylinder Head Gasket And Alignment Pins - Right

Courtesy of GENERAL MOTORS CORP.

Remove and discard the cylinder head gasket.

Fig 6: Cylinder Head Locator Pins

Courtesy of GENERAL MOTORS CORP.

Remove the cylinder head locator dowel pins, if required.