LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1062 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Propeller Shaft Center Support Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Center Bearing Assembly To Propeller Shaft
    GM1994017Courtesy of GENERAL MOTORS CORP.
  1. Place the propeller shaft assembly (3) on a block of wood.
  2. Position the center bearing assembly (2) on the propeller shaft (3).
  3. Using the J 5590  or J 25234  (1), install the center bearing assembly (2) on the propeller shaft (3).
    4. Fig 2: Installing Propeller Shaft Boot Retainer On Center Bearing Assembly
    GM1994019Courtesy of GENERAL MOTORS CORP.
  4. For HD vehicles, use the J 25234  (1) to install the propeller shaft boot retainer (2) on the center bearing assembly (3).
  5. Install the propeller shaft assembly. Refer to Two-Piece Propeller Shaft Replacement 
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals