LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1061 (Front Drive Axle) >> Repair Instructions >> Vent Hose Replacement (8.25 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vent Hose
    GM1690649Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose to the inner fender.
  2. Raise the vehicle.
    3. Fig 2: Locating Vent Hose & Components
    GM1689174Courtesy of GENERAL MOTORS CORP.
  3. Install the vent hose retainers to the frame.
  4. Install the vent hose to the connector.
  5. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals