Removal Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the lower control arm crossmember. Refer to Drivetrain and Front Suspension Frame Front Crossmember Replacement (1500, 2500 LD) .
- Drain the differential carrier. Refer to Front Axle Lubricant Replacement .
- Remove the wiring harness from the differential carrier, if needed.
- Remove the electrical connector from the actuator motor.
- Remove the differential carrier vent hose.
- Remove the wheel drive shaft mounting bolts.
- Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
- Support the differential carrier with a transmission jack.
- Remove the right differential carrier mounting nuts and washers.
- Remove the left differential carrier mounting bolts.
- With the aid of an assistant, pivot the differential carrier forward and down to remove the it from the vehicle.
- Remove the differential carrier assembly from the vehicle.
IMPORTANT:
If removing the differential carrier assembly to service other components, it is not necessary to drain the differential carrier.