LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1061 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement (1500 FWD)  or Differential Carrier Assembly Replacement (2500 4WD) .
    2. Fig 1: Remove Upper Differential Carrier Assembly Bushing Using J 36616-2, J 33791-1, Thrust Bearing, J 21474-18 & Forcing Screw
    GM893247Courtesy of GENERAL MOTORS CORP.
  2. Remove the upper differential carrier assembly bushing by performing the following steps:
    1. Install the J 36616-2 (1), the J 33791-1 (2), the thrust bearing (3), the J 21474-18 (4), and the forcing screw as shown.
    2. Remove the upper differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
    3. Fig 2: Removing Lower Differential Carrier Assembly Bushingj 21474-18, Thrust Bearing, J 33791-1, J 36616-2, & Forcing Screw
    GM892847Courtesy of GENERAL MOTORS CORP.
  3. Remove the lower differential carrier assembly bushing by performing the following steps:
    1. Install the J 21474-18 (1), the thrust bearing (2), the J 33791-1 (3), the J 36616-2 (4), and the forcing screw as shown.
    2. Remove the lower differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
scientia non olet · About LEMON Manuals