Circuit/System Testing
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Turn OFF the ignition and disconnect the water in fuel sensor.
- Turn ON the ignition and clear the DTC.
- Start and run the engine.
- If this DTC resets, test the indictor control circuit for high resistance or a short to ground.
- If the DTC does not reset, refer to Water-in-Fuel Lamp Always On .