LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1057 (Engine Controls And Fuel - 6.6L - DTC P1224 To DTC P2463) >> DTC P2032 or P2033 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Perform the Repair Verification after performing the Circuit/System Testing.
  1. Ignition OFF, disconnect the harness connector at the EGT sensor 2.
  2. Ignition OFF for 90 seconds, test for less than 5 ohms between the low reference circuit terminal B and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, verify the scan tool EGT Sensor 2 parameter is greater than 998°C (1,828°F).
    • If less than the specified range, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the ECM.
  4. Install a 3A fused jumper wire between the signal circuit terminal A and the low reference terminal B. Verify the scan tool EGT 2 parameter is less than -35°C (-31°F).
    • If warmer than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the EGT sensor.
scientia non olet · About LEMON Manuals