Circuit/System Verification
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Engine running, command the affected cylinder deactivation solenoid ON and OFF, with a scan tool, while observing the following cylinder deactivation control circuit status parameters.
- Cylinder 1, 4, 6, or 7 solenoid control Ckt. Short Gnd Test Status
- Cylinder 1, 4, 6, or 7 solenoid control Ckt. Open Test Status
- Cylinder 1, 4, 6, or 7 solenoid control Ckt. Short Volts Test Status
Each parameter should toggle between OK and Not Run or Not Run and OK
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.