LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1051 (Engine Controls And Fuel - 6.6L - DTC P02E7 To DTC P0699) >> DTC P02E8 or P02E9 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the IA valve. Allow up to 2 minutes for the ECM to completely power down.
  2. Ignition OFF, test for less than 5 ohms between the low reference circuit terminal C and ground.
    • If greater than 5 ohms, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, test for 4.8-5.2 volts between 5-volt reference circuit terminal F and ground.
    • If less than 4.8 volts, test 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than 5.2 volts, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Verify the scan tool IAF valve position sensor voltage is less than 0.1 volt.
    • If greater than 0.1 volt, test the signal circuit terminal E for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Install a 3A fused jumper wire between the signal circuit terminal E and the 5-volt reference circuit terminal F of the IA valve harness connector. Verify that the scan tool IAF position sensor voltage is more than 4.8 volts.
    • If less than 4.8 volts, test the IA valve signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  6. If all circuits test normal, replace the IA valve.

scientia non olet · About LEMON Manuals