Circuit/System Description
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
The intake air (IA) valve is a normally open valve and is only operated during a DPF regeneration. The position of the IA valve is controlled by the engine control module (ECM). The IAF Valve system uses a position sensor located within the valve assembly to monitor the position of the valve. The position sensor has the following circuits:
- 5-volt reference circuit
- Low reference circuit
- Signal circuit
The IAF valve uses a motor to move the valve to a closed position and spring tension returns it to the open position. The motor has the following circuits:
- Motor control 1 circuit
- Motor control 2 circuit